install on PC with builtin wifi adapter

[eram]

I'm trying to setup a server on a PC that has an ethernet interface connected to the internet and a wifi interface that I want to use as the Visitor Network interface.
Server does not start.
I've also tried to setup a virtual adapter with hosted network (updated bindings, config.ini) - getting the same error.

is this topology supported?

hosted networkcommands:
netsh wlan set hostednetwork mode=allow ssid=eram key=12345678
netsh wlan start hostednetwork

the error I get:

Mon Jan 12 16:18:17 2015 ***** All the error messages of session started at Mon Jan 12 16:18:17 2015 are shown below *****
Mon Jan 12 16:18:39 2015 Visitor network interface card is disconnected.
Mon Jan 12 16:32:40 2015 ***** All the error messages of session started at Mon Jan 12 16:32:40 2015 are shown below *****
Mon Jan 12 16:32:49 2015 Fail to find the visitor network connection VirtualWiFi.
Mon Jan 12 16:42:46 2015 ***** All the error messages of session started at Mon Jan 12 16:42:46 2015 are shown below *****
Mon Jan 12 16:42:48 2015 Fail to find the visitor network connection VirtualWiFi.

[alan]

First, make sure you don't change Windows Network Connection name after you install FirstSpot.

Currently, FirstSpot only supports using Ethernet card as Visitor Network Interface. Refer to http://patronsoft.com/firstspot/topologies.html for typical network topologies setup.
_________________
~ Patronsoft Limited ~